CO2 LASER PARAMETERS CO2 laser parameters for: LS100, LS100EX (40 W) This document provides a base of engraving parameters to be used on Gravotech laserable materials. They are indicative values that can be subject to modification, that are recommended by professional engravers and have been tested and verified for the LS100Ex & LS100 40 W. The purpose of this document is to help each engraver get an idea as to how to engrave on Gravotech laserable materials. The parameters are sorted by product range. Every material can have up to 3 different types of engraving process: • Vector, for lightweight linear tracing • Raster, for heavy marking • Cutting Some materials may not be engraved with a certain type of engraving process: if the specific type is not in the grid of the material, then it's most likely that it we do not recommend this engraving method on the indicated material. Power Speed Passes Focus Refocus Air Type Dpi Thickness Comments Gravoply™ 2 10% 100% 1 - Before no Vector 500 - 50% 100% 1 - Before no Raster 500 - Metallex™ 10% 100% 1 - Before no Vector 500 - 40% 100% 1 - Before no Raster 500 - All Metallex™ material surfaces Gravoxal™ 30% 100% 1 - Before no Vector 500 - All Gravoxal™ material surfaces 50% 100% 1 - Before no Raster 500 - All Gravoxal™ material surfaces AlumaMark® 30% 50% 1 - Before no Vector 500 - 30% 80% 1 - Before no Raster 500 - DuraBlack® 20% 80% 1 - Before no Raster 500 - TECH TIPS Floating pin table cutting - When using a floating pin table, place an aluminium plate under the strips to avoid laser reflection to prevent engraving under the material. Gravogrip™ : • Use Gravogrip™ when engraving on thin materials as they can have uneven surfaces. • Avoid using too much power when engraving to prevent damage to the Gravogrip™ plate. Note : in case of unexpected behavior during the engraving process, please refer to the machine's User Manual for troubleshooting. ENGRAVING MATERIALS (NO LASER CUTTING) 148
RkJQdWJsaXNoZXIy MTg0MDcwNg==