96 GIFTS Engravables www.gravostoreUSA.com CO2 Corner Jigs ¼,½,¾ jigs 63066 Laser Bed Aligment Laser Alignment Plate 63085 Troubleshooting If your machine will not allow the offset you need to enter, you’ll need to reset your fence. In the package of tools that arrived with the machine, there will be an allen wrench that will fit the screws along the rulers on the X and Y axis. Move the rulers as far in as possible. Run your red light along each axis to ensure the rulers are secured straight. Laser Bed Alignment 1. Place the alignment plate in the top left corner of the laser bed 2. Run this file 3. Measure the offset between the box you lasered, and the box that was already lasered. 4. Turn the laser off, then back on. 5. As soon as the word "Gravograph" appears on the display, press and hold the X button. 6. Select the option "ReAlign Machine" 7. Select the option (ReAlign X Y) 8. Increase or decrease the X and Y values by the offset you measured 9. Press the check button, it will beep if the new values are accepted. These jigs are used when engraving the product. Alder Alder 12"W x 5"H, 25 pc 51086 Cleaning Tissue Laser optics cleaning tissue 51213 Cleaning Swabs Laser optics cleaning swabs, 10 pc 30864 Magnets 1½"W x 2"H 150 pc 63056 ACCESSORIES
RkJQdWJsaXNoZXIy MTg0MDcwNg==